![]() A snap-down tilt bail is featured on the bottom panel to increase the operating angle. There are also "plus" and "minus" terminal outputs (10 Amps max). The rear panel has a hard-wire Kenwood power cable to connect directly to the TS-430S. The power supply employs a 6 Amp AC fuse and 20 Amp DC fuse. Ripple voltage is less than 20 mW at 13.8 VDC 15 A. web site:- The Kenwood PS-430 power supply provides 13.8 VDC at 20 Amps intermittent (25% duty cycle), 15 Amps standard (50% duty cycle) or 10 Amps maximum at continuous load. Here's the PS-430 Specifications, from the Universal Radio, Inc. This is a linear power supply, which is quite heavy compared to a switching power supply. The AC input voltage is either 120V or 240V AC, and a 120V AC power cord is included. This particular PS-430 was used with a Kenwood TS-430, which has already been sold. It was the main AC Power Supply that was for use with the Kenwood TS-430 and TS-440 HF Amateur Radio Transceivers. It provides 13.8V DC Power to run a Kenwood (or other brand) typical 100-watt output Ham Radio Transceiver. ![]() This is a Kenwood model # PS-430 AC Power Supply that came from a local Amateur Radio Operator's estate. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |